Installation Wall-Mounting - DeLonghi STRETTO Instructions Manual

Installation wall-mounting

The wall mounting kit should contain:
2 x Upper brackets (A)
1 x Lower brackets (B)
5 x screws
1. Select position for locating the heater ensuring that:
a. It is not located directly below a power socket outlet.
b. The plug and power outlet can be easily reached after
installation.
c. No electric cables or other tubes could be damaged.
d. Keep away from curtains or inflammable materials. Also
note the minimum distances indicated in the figure 2.
Important
Before drilling into any wall ensure no electrical cables are present
in the area, especially hidden in the wall. (if in doubt, consult a qual-
ified electrician).
2. Following carefully the dimensions as indicated below (the dis-
tance depends on which model you have purchased) mark dis-
tance "D" on your wall.
Model
1 Kw
1,5 Kw
2 Kw
2,5 Kw
3. Line up the centre of the holes of the brackets "A" with the
marked lines (indicated in fig 3 and 4 as the dashed lines)ensur-
ing that the 2 brackets are level, mark the holes to be drilled.
4. For solid brick block walls, use a 6 mm masonry drill and drill the
fig.3
mm
Distance
140 mm
D
210 mm
D
280 mm
D
385 mm
D
5
Ceiling
250mm
Walls/
furnishings
150mm
Fig.2
Floor
Minimum distances
from surrounding
walls/ furnishings
D
D
fig.4
Stretto