Honda CBR1000RR Owner's Manual page 86

7. Remove the oil filter with a filter wrench
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
u Discard the oil and oil filter at an
approved recycling centre.
Rubber
seal
Oil filter
Engine Oil u Changing Engine Oil & Filter
8. Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
9. Install a new oil filter and tighten.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft).
10. Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft).
11. Fill the crankcase with the recommended
oil ( P. 66) and install the oil fill cap.
2
Required oil
When changing oil &
engine oil filter:
3.0 litres (3.2 US qt, 2.6 Imp qt)
When changing oil only:
2.8 litres (3.0 US qt, 2.5 Imp qt)
12. Check the oil level.
13. Check that there are no oil leaks.
14. Install the lower cowl.
P. 80
2
83