Pontiac Montana SV6 2007 Owner's Manual page 15

To return the seat to the original position, do the
following:
1. Align the seat so that the rear hooks on the
seat are over the rear floor pins. Push down
firmly on the rear of the seat so that the
rear hooks attach to the rear floor pins.
2. Try to raise the seat to check that it is locked
to the floor.
4. Release the rear set
of seat hooks from
the floor pins by
pulling the nylon
strap, located at the
base of the seat. Use
the strap to guide the
seat forward.
3. Pull the nylon strap, located on the rear right
hand side of the seat, or lift the recline lever,
located on the front right hand side of the
seatback, to raise the seatback to the upright
position.
CAUTION:
{
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on the
seatback to be sure it is locked.
4. Push and pull on the seatback to check that it
is locked.
15