Table of Contents
Advertisement
to the receptacle must be provided for use
with the optional blower kit whether installed
during or after initial firebox installation. You
may not be able to install a supply connection
after the final installation is completed. Refer
to Optional Blower Assembly Installation for
specifics.
OPTIONAL BLOWER ASSEMBLY
INSTALLATION
Proper installation of the blower system is re-
quired to insure that the maximum discharge
of air can be delivered through the louvers on
each side of the fireplace.
Note: You may perform this installation from
either side of the fireplace within either room.
The lower door panels are removable from
both sides of the firebox for better access.
1. Remove blower assembly from packaging
and inspect fan and wiring for damage. If
any wiring is loose or damaged, return
assembly for exchange to your dealer or
distributor.
2. Remove bottom louver by pulling both
spring latches (located in each end of
louver) toward center of appliance at the
same time until disengaged from locating
holes in firebox (see Figure 16).
3. Locate 2 strips of hook and loop mounting
strips on one side of base of lower com-
partment. Align mounting strips on blower
with mounting strips on base of firebox.
4. Install blower housing with exhaust outlet
ports directed upwards along inner side
wall of lower compartment. The blower
outlets must be installed flush to the outer
cabinet for air to flow properly.
Bottom Louver
Figure 16 - Removing Bottom Louver
14
INSTALLATION
Continued
Locating
Holes
Spring Latch
www.SuperiorFireplaces.US.com
5. Apply gentle force between hook and loop
mounting strips to seat blower.
6. Remove control knob and lock nut from
blower speed control shaft.
7. Place speed control shaft through 3/8"
hole provided in right side of lower door
panel removed in step 2.
8. While supporting speed control housing,
secure shaft in panel hole with lock nut.
Place control knob on shaft.
9. Plug blower power cord into receptacle
located in lower firebox compartment.
Check to make sure there are no foreign
objects in blower wheel.
WARNING: Never touch blow-
er wheel while in operation.
10. Turn blower on and check for proper
operation.
11. Turn blower off before continuing.
12. Replace lower door panel by inserting tabs
on bottom of panel into locating slots on
firebox. Push door panel into an upright
position and secure with screws removed
in step 2.
126703-01A
Advertisement
Table of Contents
