Table of Contents
Advertisement
PERIMETER TRIM KIT (PROVIDED)
1. Remove packaging from three pieces of
trim.
2. Locate the two adjusting plates with set
screws and two shims in the hardware
packet.
If any of these pieces are missing or dam-
aged, contact the dealer where you pur-
chased this kit or FMI PRODUCTS, LLC
at 1-866-328-4537 for referral information.
You can also visit FMI PRODUCTS, LLC's
web site at www.fmiproducts.com.
3. Align shim under adjusting plate as shown
in Figure 50.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top trim (see
Figure 50).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side trim (see
Figure 50).
Set Screws
Side Trim
Adjusting
Plate
Mitered Edge
Slot
Figure 50 - Assembling Trim
111986-01G
FIREPLACE INSTALLATION
Continued
Top Trim
Shim
Slot
www.fmiproducts.com
6. While firmly holding edges of trim together,
tighten both screws on the adjusting plate
using a slotted screwdriver.
7. Repeat steps 2 through 6 for other side.
8. Place the assembled trim onto firebox
cabinet. Align hanging notches on trim
with trim hanging shoulder screws (see
Figure 51). Tap trim firmly into place with
palm of hand or rubber mallet by engag-
ing hanging notches around shoulder
screws. Start at one end of the trim and
work around firebox until all notches are
fully engaged.
Assembled Trim
Figure 51 - Attaching Trim to Firebox
Trim Hanging
Shoulder Screw
Locations
Hanging
Notches
on Trim
27
Advertisement
Table of Contents
