Saeco XSMALL HD8644 User Manual page 46

ENGLISH
44
Problem
The descaling cycle cannot
be finished.
The machine grinds the
coffee beans but no coffee is
brewed (see note).
The coffee is too weak (see
note).
Coffee is brewed slowly (see
note).
The drip tray gets filled al-
though no water is drained.
Note:
These problems can be considered normal if the coffee blend has been changed or if the machine has just been
installed. In this case, wait until the machine performs a self-adjusting operation as described in the "Saeco Adapt-
ing System" section.
Possible Cause
Most probably you have used not
enough water for rinsing.
The brew group is dirty.
The water circuit is not primed.
This might occur when the ma-
chine is automatically adjusting
the dose.
The coffee dispensing spout is
dirty.
This might occur when the ma-
chine is automatically adjusting
the dose.
The ceramic coffee grinder is set
to a coarse grind.
The coffee grind is too fine.
The water circuit is not primed.
The brew group is dirty.
Water is drained automatically by
the machine into the drip tray to
manage the rinsing of the circuits.
Solution
Unplug the power cord and follow
the instructions described in the
sector " Interruption of the descaling
cycle".
Clean the brew group ("Brew Group
Cleaning" section).
Fill the water tank with fresh water
and dispense hot water.
Brew a few cups of espresso coffee
as described in the "Saeco Adapting
System" section.
Clean the coffee dispensing spout.
Brew a few cups of espresso coffee
as described in the "Saeco Adapting
System" section.
Adjust the ceramic coffee grinder to
a finer setting (see the "Adjusting the
Ceramic Coffee Grinder" section).
Change coffee blend or adjust the
grind setting as explained in the "Ad-
justing the Ceramic Coffee Grinder"
section.
Fill the water tank with fresh water
and dispense hot water.
Clean the brew group ("Brew Group
Cleaning" section).
This is a standard operating proce-
dure.