Levelling The Machine; Room Ventilation; Before Moving The Tumble Dryer Again (E.g. When Moving House) - Miele T 7644 C Operating Instructions Manual

Installation and connection

Levelling the machine

The machine must be perfectly level to
ensure safe and proper operation.
^ The screw feet can be adjusted to
compensate for any unevenness in
the floor.
38
,
The air inlet and outlet vents on
the front and back of the machine
must not be covered as this would
prevent sufficient ventilation for coo-
ling the condenser unit.
,
Do not block the gap between
the bottom of the tumble dryer and
the floor with plinth facings, deep file
carpet etc. This would hinder a suf-
ficient flow of air to the dryer.

Room ventilation

The air which is taken in when the
dryer is in operation is blown out of
the vents on the front of the machine
and warms up the air in the room.
It is very important, particulary if the
room is small, to ensure adequate
ventilation. Opening a window, for
example, will allow more air to enter
the room. Otherwise running times
and energy consumption could be
increased.
Before moving the tumble dryer
again (e.g. when moving house)
After each use a small quantity of con-
densed water will collect in the area
around the pump. This water can run
out if the dryer is tipped up when it is
being moved. It is a good idea to run
the Cool air programme for approxima-
tely 1 minute before moving it . Any re-
maining condensed water will then be
fed into the condensed water container
or out through the drain hose.