Miele T 7634 Operating Instructions Manual

Miele T 7634 Operating Instructions Manual

Vented tumble dryer
Table of Contents

Advertisement

Operating instructions
for vented tumble dryer
T 7634
G
To avoid the risk of accidents
or damage to the machine
it is essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 06 737 030

Advertisement

Table of Contents
loading

Summary of Contents for Miele T 7634

  • Page 1 Operating instructions for vented tumble dryer T 7634 To avoid the risk of accidents or damage to the machine it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 06 737 030...
  • Page 2: Caring For The Environment

    To avoid unnecessarily long drying bags etc. are disposed of safely and times and high consumption of energy: kept out of the reach of babies and young children. Danger of suffocation! – Make sure that your laundry is thoroughly spun before drying.
  • Page 3: Table Of Contents

    Cleaning the grilles in the door opening ....... . 22...
  • Page 4 Calculating the effective duct length: ........35...
  • Page 5: Warning And Safety Instructions

    The manufacturer cannot be increasingly available on the market. If held liable for the consequences of an using, do so at your own risk, and inadequate earthing system (e.g. follow the instructions provided on the electric shock).
  • Page 6 Repairs should only be undertaken by a Miele approved technician. Ensure current is not supplied to the machine until after maintenance or repair work has been carried out. Faulty components must only be replaced by genuine Miele original spare parts.
  • Page 7 (e.g. gas, oil or coal fired heater, continuous flow – it is switched off at the wall socket or other water heater) is installed in the and the plug is withdrawn, or same or an adjacent room.
  • Page 8 Do not allow children to play on or near it or to play with its controls. Supervise – items which contain damaged its use by the elderly or infirm.
  • Page 9: Operating The Tumble Dryer

    - Delaying the start of a programme with indicator lights c Buzzer button i Door button An audible tone sounds at the end of Pressing this button will open the the programme. door even when the machine is d Check lights switched off at the mains.
  • Page 10 This – Delay start can happen with particularly fine fabrics, very small loads or if items – Duration of the Cool air and Warm air were partly dry beforehand. programmes – Programmable functions Delay start...
  • Page 11: Notes On Laundry Care

    ... Dry at low temperature dried if specified as suitable by the s ....Do not tumble dry manufacturer on the care label, as...
  • Page 12: How To Dry Correctly

    ^ Press the Door button to open the The headings numbered (A, B, C ...) show the operating sequence and can door. be used as a brief guide to using your ^ Load the laundry loosely into the machine. drum.
  • Page 13 (see "Programme duration / Estimated time remaining"). You cannot alter the drying level of the and Smoothing programmes. Select the duration for the Cool air and Warm air programmes The indicator light for the Delay start ^ Select the programme you want.
  • Page 14 It will go out a few There is no cooling down phase at the minutes later to save energy. end of the following programmes: ^ Switch the dryer off by pressing the Woollens handcare, Smoothing.
  • Page 15: Additional Options

    – If you keep the Delay start button pressed in, the time will continue to For drying delicates and fabrics with increase up to 24^. the r symbol on the care label at a To begin delay start lower temperature. ^ Press the Start/Stop button.
  • Page 16: Programme Chart

    Cottons or linen fabrics, e.g.: table linen, bed linen, starched laundry. Note – To prevent laundry from drying out it should be rolled up until you are ready for ironing. Low temperature Also select the Low temperature option for delicate fabrics with the r symbol on the care label.
  • Page 17: Automatic Normal

    – Minimum iron items made of mixed fibres, cottons or synthetics, e.g.: trousers, jackets, shirts. Notes – Smooths out creasing caused during the spin cycle in the washing machine. – Fabrics are not completely dried in this programme. Remove garments as soon as the programme has finished and leave to finish drying at room temperature.
  • Page 18 Note Do not select the longest drying time to start with. Check the items as you are drying them to find the optimum time. You can use the Warm air programme to help remove odours from cotton clothing which has been worn but it still clean (select a duration of between 1/2 and 1 hour).
  • Page 19: Changing The Programme Sequence

    Do not touch the back of the reached and how long they have drum when adding or removing been dried for. items. The drum could be very hot - If you press the Start/Stop button danger of burning. again during the cooling down phase, Finish will light up in the ^ Add or remove items as required.
  • Page 20: Electronic System Lock

    The dryer's electronics are then locked. The indicator light for the Low The dryer can still be switched on but a temperature button will flash and a key programme cannot be started. symbol 0-§ will appear in the display.
  • Page 21: Cleaning And Care

    Miele dealer or the Miele Spare Parts Department, or use a vacuum cleaner. ^ Also clean the door seal (2) with a damp cloth. ^ Once clean, push the filter back into the door holder until it clicks into position.
  • Page 22: Cleaning The Grilles In The Door Opening

    The machine must never be hosed down. ^ Turn dial a on each grille until you hear it click. ^ Dry all parts with a soft cloth. ^ Take hold of the dial, and pull the...
  • Page 23: Problem Solving Guide

    Problem solving guide With the help of the following notes, minor faults in the performance of the machine, some of which may result from incorrect operation, can be put right without contacting the Service Department. Repair work to electrical appliances should only be carried out by a suitably qualified person in strict accordance with current local and national safety regulations.
  • Page 24 Remedy The Clean out This indicator light comes on – Cleaning the fluff filter is airways to warn you that the dryer is usually all that is required. However, if the Clean out indicator light not working efficiently. comes on.
  • Page 25: Other Problems

    Other problems Problem Possible cause Remedy The drying Please check all the possible causes and switch the process goes on dryer off and then back on again. too long or even Ventilation to the dryer is Open a door or window while switches off.
  • Page 26 (see and washed. Machine "Cleaning and care"). drying hardly causes any fluff to form and has been established by research institutes to have no appreciable effect on the lifetime of fabric.
  • Page 27 – Is the plug correctly inserted into the socket and switched on? – Is the door closed properly? – Has the fuse or circuit breaker tripped? The interior drum The lighting switches off Switch the dryer off and lighting does not come automatically (to save then on again.
  • Page 28: Changing The Lamp

    ^ To close the cover push it upwards You will find the interior lamp cover at the top of the drum aperture. and press it on the left and right until you hear it click into position. Ensure that it is fitted into position securely, as any moisture could cause a short circuit.
  • Page 29: After Sales Service

    After sales service Repairs Future updates (PC) In the event of any faults which you The indicator light marked PC is the cannot remedy yourself, or if the interface used by Miele service machine is under guarantee, please technicians during service work for...
  • Page 30: Installation And Connection

    Installation and connection Front view a Venting connection: rear, right or left (supplied with the rear socket open) b Mains connection cable c Control panel d Door e Four height adjustable screw feet...
  • Page 31: Rear View

    Protruding lid for holding when When moving the machine, you can hold it by the lid where it protrudes to moving the machine (see arrows) the rear of the dryer. To manoeuvre the b Mains connection cable...
  • Page 32: Levelling The Machine

    Room ventilation The dryer operates by drawing in air from the room in which it is located. It is therefore very important to ensure that there is adequate ventilation in the room, by opening a window, for example.
  • Page 33: Electrical Connection

    The regulations (BS 7651 in the UK).
  • Page 34: Installation - Venting

    – for venting to the outside: connected to the power supply. a wall pipe kit* or a window vent kit*. – The ducting outlet (e.g. wall pipe) * Available as an optional accessory should be installed in such a way from your Miele dealer or the Miele that the moist expelled air .
  • Page 35: Calculating The Effective Duct Length

    Installation - venting Calculating the effective duct 2. Internal duct diameter length: ^ Refer to Table II for the appropriate duct diameter required. Friction against the inner walls of the ducting will slow down the expelled air Table I as it passes through. An elbow, bend,...
  • Page 36: Installation To The Rear, Left Or Right Side Of The Machine

    Result: A duct diameter of 100 mm is ^ Refit it securely in the rear outlet. adequate as the effective duct length is ^ Fit one of the venting systems less than the 20 m specified in Table II. described on the following pages.
  • Page 37: Venting Systems

    Connecting directly to a wall vent ^ The following items are required: ..flexible ducting hose . . . a wall vent kit* or window vent kit*. * (Miele optional accessory). A Insert adapter (1) into the vent opening on the dryer.
  • Page 38 3. Exhaust flue insulated against damp kit) 2. Adapter for flexible hose The ducting must not be vented into a chimney or vent flue which is in use, nor should it be connected to ducting which ventilates rooms with fireplaces.
  • Page 39: Plastic Piping

    The following items are required: – An adapter* (C 100 mm). – A wall vent kit* or window vent kit*. – Suitable piping (C 100 mm) is 1. Wall vent kit available from your dealer or builders (Separate fitting instructions are merchants.
  • Page 40: Connect Directly To A Wall Vent

    Connect directly to a wall Side view: vent The best method of venting the dryer is to connect it directly to the outside wall of a room. Time and energy consumption are better with plastic piping. This involves boring through an outside wall.
  • Page 41: Washer-Dryer Stack

    Installation - venting Washer-dryer stack Stacking kit* without pull-out shelf: A = 94.2 cm B = 170 cm Stacking kit* with pull-out shelf: A = 96 cm B = 172 cm * Miele accessory available to order...
  • Page 42: Consumption Data

    All data without a "star" against it was calculated using EN 61121:2000. Before testing in accordance with EN 61121, dry a 3 kg load of cotton laundry with 70% residual moisture as per the above standard using the Cottons Normal programme without any additional options.
  • Page 43: Technical Data

    Height 850 mm Width 595 mm Depth 634 mm Depth with door open 1074 mm Suitable for pushing under a worktop Suitable for stacking Weight 46 kg Drum volume 111 litres Maximum capacity 6 kg dry weight Length of connection cable...
  • Page 44 Programmable functions for changing default settings The programmable functions are used to alter the machine's electronics to suit changing requirements. Programmable functions can be altered at any time.
  • Page 45: Programmable Functions

    – Indicator lights Machine iron and Hand iron = Machine iron+ B Press the I-On/0-Off button in. Wait until the indicator light for the Start/Stop button lights up constantly . . . C . . . and then release the Start/Stop button.
  • Page 46: Altering The Volume Of The Buzzer

    The buzzer sounds at the end of a Start/Stop button lights up programme (default setting). constantly . . . C . . . and then release the Start/Stop Loud The buzzer sounds at maximum volume button. at the end of a programme.
  • Page 47: Memory Function

    Start/Stop button lights up Delay start period selected will also constantly . . . be stored in memory. C . . . and then release the Start/Stop These settings will be selected button. automatically the next time the D Press the Low temperature button programme is chosen.
  • Page 48: Extending The Cooling Down Time

    Start/Stop button lights up makes the garments easier to constantly . . . handle. C . . . and then release the Start/Stop The cooling down time button. – can be extended by 5 minutes or 10 D Press the Low temperature button minutes.
  • Page 49: Clean Out Airways Indicator

    Start/Stop button lights up in the filters. You can decide at what constantly . . . level of fluff this reminder should be C . . . and then release the Start/Stop given. button. You will have an idea of which of the...
  • Page 50: Keypad Tone

    Start/Stop button lights up constantly . . . Before you begin, first ensure that: C . . . and then release the Start/Stop – The tumble dryer is switched off. button. – The door is closed.
  • Page 51: Adjusting The Dryer's Electronics For Very Soft Water

    If the machine is installed in an area constantly . . . with very soft water, you should contact your local water supplier for C . . . and then release the Start/Stop information and advice regarding button. water hardness and water D Press the Low temperature button six conductivity.
  • Page 52 Alteration rights reserved/0906 M.-Nr. 06 737 030 / 00 en - GB...

Table of Contents