Use Of The Remote Control - Carrier 42PQV Owner's Manual

42PQV

Use of the remote control

Sleep timer procedure "night"
Press this button to set the SLEEP timer with remote control on.
The icon will apear on the display.
This prodedure permits setting the remaining unit operating time.
1.
"1:hr" will be displayed together with the
icon.
2.
Press button
The display will show the following
settings in sequence:
1 hr, 2 hr, 3 hr, 4 hr, 5 hr, 6 hr, 7 hr and 9:hr.
3.
Once the remaining operating hours have
been selected with either button
again press button
4.
When the SLEEP timer is set, the unit will
control the set temperature to avoid
ovecooling or overheating during operation.
The set temperature will change as follows:
10
(button M)
(temperature increase).
or ,
to confirm.
Current time adjusting
(buttons N and O)
Press current time adjusting button
Press reset button "O" with a sharp object if the remote control is
not operating properly or after replacing the batteries.
Setting current time
1.
With the remote control ON or
OFF, keep pressing button
at least 5seconds.
2.
The current hour figure flashes.
Press either button or
to set the current hour.
Press button to move to
minutes and set them.
3.
For this setting always use
either button or .
4.
Once the current time is set,
press button to confirm it.
Address selection
If you have two indoor units in the same room, you can link one
remote control to one indoor unit, and the other remote control to
the other indoor unit, or you can control both indoor units with a
single remote control.
For configuration, refer to the installation manual.
and reset buttons
to adjust the current time.
(button N)
for
PM