Tyre Chains - Chevrolet 2015 Spark Owner's Manual

10-42 Vehicle Care
11. Align the valve hole in the
wheel cover with the tyre valve
before installing.
Install wheel nut caps.
12. Stow the replaced wheel and
the vehicle tools. To prevent
the rattling noise, turn screw
head until the top and bottom
of the jack are completely
squeezed to the toolbox after
returning the jack to its original
position. At this time, make
sure that jack has some
clearance to any vehicle tool.
0
Tools Tools on page 10-30.
13. Check the tyre pressure of the
installed tyre and also the
wheel nut torque as soon as
possible.
Have the defective tyre renewed or
repaired.
{
Warning
Rust or dirt on a wheel, or on the
parts to which it is fastened, can
cause the wheel nuts to become
loose with time. The wheel could
come off and cause an accident.
When changing a wheel, remove
any rust or dirt from places where
the wheel is attached to the
vehicle. In an emergency, a cloth
or a paper towel can be used;
however, use a scraper or wire
brush later to remove all rust
or dirt.
Lightly coat the centre of the wheel
hub with wheel bearing grease
during a wheel change to prevent
corrosion or rust build-up. Do not
get grease on the flat wheel
mounting surface or on the wheel
nuts or bolts.

Tyre Chains

Tyre chains are only permitted on
the front wheels.
Always use fine mesh chains that
add no more than 10 mm to the tyre
tread and the inboard sides
(including chain lock).
{
Warning
Damage may lead to tyre
blowout.