Tube Channel Assembly Replacement - Quadra-Fire 27I-ACC Owner's Manual

F. Tube Channel Assembly Replacement
Removing Tube Channel Assembly
1. Remove the 3 bottom bricks fi rst and then remove the 3
right side bricks.
2. Remove the baffl e protection channel by bending back
the tabs using needle nose pliers located at the right and
left side of the protection cover. Lift the cover up slightly
and pull toward the front and out of the fi rebox. Figure
25.1.
3. Locate the 2 channel nuts inside of chamber and remove
using a 7/16 socket wrench. Figure 25.2.
NOTE: Soak the bolts with penetrating oil for at least 15 min-
utes before trying to remove them.
4. Slide the tube channel assembly all the way to left until it
is off the threads. Drop the right side down, then slide the
assembly back to right. Figure 24.1 on page 24.
5. The ceramic blanket and both baffl e boards can be
removed at the same time you remove the tube channel
assembly.
6. When the tube channel assembly is free of the left side
support, rotate clockwise and pull assembly, blanket and
baffl es out through the front opening.
7. Re-install in reverse order.
2 Tube Channel Nuts
Ceramic Blanket
Figure 25.3
April 30, 2015
Tube Channel
Assembly
2
Baffle Boards
Baffle Protection Channel
7046-191C
Bend Back Tabs
Fig. 25.1
Use 7/16 Socket Wrench
and Remove Channel Nuts
Fig. 25.2
1
3
4
Rotate and
remove from
firebox
1
1
1
3
4
Baffle Protection
Channel
2
27I-ACC
25