F-60
T1 TRANSFORMER REMOVAL AND REPLACEMENT (continued)
PROCEDURE
1. Remove input power to the LN-9 GMA.
2. Using the phillips head screwdriver remove the
screws holding the left side cover assembly.
3. Lift the cover.
TROUBLESHOOTING & REPAIR
FIGURE F.17 – PRIMARY LEAD #31 AT R1 RESISTOR
LN-9 GMA Wire Feeder
LEAD 532
R1 RESISTOR
LEAD 31
4. Disconnect primary lead #532 from the power
PC board terminal.
5. Disconnect the primary lead #31 from the R1
(2 ohm) resistor.
See Figure F.17.
reassembly this lead will have to be soldered
onto the R1 resistor.
F-60
Upon