Connecting To A Wps Network - Denon HEOS Owner's Manual

Contents

Connecting to a WPS Network

If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS Wireless Speaker can optionally connect to your
network using the "Push Button" method by following these steps:
1. Press the WPS button on your router.
2. Within 2 minutes, Press and Hold the Connect button on the rear panel of the HEOS speaker for 5 seconds.
3. The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the speaker will turn solid blue.
Resetting Your Speaker
Resetting your speaker will clear out the wireless network info, EQ, and name but retain it's current software. You will have to use
Settings - Add Speaker to reconnect the speaker to your home network before it can be used.
To reset your speaker, gently insert a small paperclip into the Reset button hole on the back of the speaker and hold it in until the
front LED begins to flash amber.
Setup Use
Solution
Solution
Troubleshooting
56
Status LED Appendix
Refer to Page
Refer to Page
6
–