Detaching And Refitting The Drive Unit - Kyocera FS-1016MFP Service Manual

2G4

(6) Detaching and refitting the drive unit

<Procedure>
1. Remove the right cover (See page P.1-5-2).
2. Remove the three connectors.
3. Remove the two screws and then remove
the two grounding plates.
4. Remove the two stoppers and then remove
the two clutches.
5. Remove the three screws and then remove
the drive unit.
6. Check or replace the drive unit and refit all
the removed parts.
1-5-20
Stopper
Grounding plate
Clutch
Screw
Stopper
Screw
Screw
Drive unit
Screw
Connectors
Clutch (black)
Grounding plate
Figure 1-5-25
Screw
Figure 1-5-26