Lincoln Electric RANGER 275 Operator's Manual page 29

C-3
ACCESSORIES - CONNECTION DIAGRAMS
RANGER 275 / LN-25 ACROSS THE ARC CONNECTION DIAGRAM
14 PIN
AMPHENOL
TO WORK
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE
AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER
VOLTMETER SWITCH TO MATCH THE POLARITY OF THE ELECTRODE CABLE.
N.C. PLACE THE MODE SWITCH IN THE "WIRE WELDING-CV" POSITION.
N.D. IF REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.
N.E. PLACE THE WELDING TERMINALS SWITCH IN THE "ALWAYS ON" POSITION.
N.F. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
RANGER 275 / LN-25 ACROSS THE ARC CONNECTION DIAGRAM
14 PIN
AMPHENOL
TO WORK
N.A. WELDING CABLES MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE
AND FUTURE APPLICATIONS. SEE OPERATING MANUAL.
N.B. CONNECT WELDING CABLES TO OUTPUT STUDS FOR DESIRED POLARITY. POSITION THE WIRE FEEDER
VOLTMETER SWITCH TO MATCH THE POLARITY OF THE ELECTRODE CABLE.
N.C. PLACE THE MODE SWITCH IN THE "WIRE WELDING-CV" POSITION.
N.D. IF REMOTE OUTPUT CONTROL IS USED, PLACE LOCAL REMOTE SWITCH IN "REMOTE" POSITION.
N.E. PLACE THE WELDING TERMINALS SWITCH IN THE "ALWAYS ON" POSITION.
N.F. PLACE IDLER SWITCH IN "AUTO" OR "HIGH" IDLE POSITION AS DESIRED.
WITH OPTIONAL K857 REMOTE CONTROL
WARNING
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
6 PIN
AMPHENOL
ELECTRODE
TO WORK
WITH OPTIONAL K444-1 REMOTE CONTROL
WARNING
Do not operate with panels open.
Disconnect NEGATIVE (-) BATTERY LEAD
before servicing.
Do not touch electrically live parts.
6 PIN
AMPHENOL
ELECTRODE
TO WORK
RANGER 275
Keep guards in place.
Keep away from moving parts.
Only qualified personnel should install,use
or service this equipment.
OPTIONAL K857
REMOTE CONTROL
LN-25
WIRE FEEDER
WORK CLIP LEAD
ELECTRODE CABLE
Keep guards in place.
Keep away from moving parts.
Only qualified personnel should install,use
or service this equipment.
OPTIONAL K444-1
REMOTE CONTROL
LN-25
WIRE FEEDER
WORK CLIP LEAD
ELECTRODE CABLE
C-3
TO WORK
A
S24095-1
TO WORK
A
S24095-2