Ip Address; Connections And Adjustments With Optional Interface Unit If-2503 - Furuno GS-100 Operator's Manual

8.4.9

IP address

IP address for your equipment
1. Press the MENU ESC key to open the main menu.
2. Select [7 System Setting] then [2 Network].
3. Select [1 Ethernet].
4. Enter the IP address for your equipment (setting range: 172.16.0.1 to
172.31.255.254), subnet mask and default gateway with the numeric keys.
5. Move the cursor to [Enter] then press the ENT key.
IP address for device receiving output sentences
1. Press the MENU ESC key to open the main menu.
2. Select [5 I/O] then [5 Ethernet].
3. Select [3 IP ADR/Port].
4. Enter the IP address (setting range: 239.192.0.1 to 239.192.0.64) and port with
the numeric keys.
5. Move the cursor to [Enter] then press the ENT key.
8.5 Connections and Adjustments with Optional In-
terface Unit IF-2503
The optional Interface Unit IF-2503 can be connected to the Display Unit GS-1002 to
interface a radar or chart plotter and alarm system.
Connect the IF-2503 to the DATA4 port of the Display Unit GS-1002. Fabricate the
MJ-A7SPF0003-050C cable as with the MJ-A6SPF0003-050C. (See the Operator's
Manual for IF-2503.) After the connection, set the following menus.
• Set [BPS] in the [Output 4] menu to [4800 bps]. (See paragraph 3.9.1.)
• Set [Mode] in the [Alert] menu to [Legacy]. (See paragraph 8.4.8.)
8. INSTALLATION
8-19