Msw Code - Sony Handycam DCR-PC1 Service Manual

2-2. MSW Code

MSW when errors occur:
Information on MSW (mode SW) when errors occur
MSW when movement starts:
Information on MSW when movements starts when the mechanism position is moved (When the L motor is moved)
MSW of target of movement:
Information on target MSW of movement when the mechanism position is moved
Mechanism Position
← UNLOAD
EJECT BL USE BL
Releasing lock of
cassette compartment
Position Code
EJECT
BL
USE
SOFF
DS
LE
STOP
FF
RP
RVS
NULL
SOFF BL DS BL
LS chassis movement range
Position at which the cassette compartment lock is released, and position at the farthest unload side
A
mechanically at which the mechanism can move no further in the UNLOAD direction.
BLANK code, at the boundary between codes. The mechanism will not stop at this code during
F
operations. (Excluding LOAD/UNLOAD)
EJECT completion position. When the cassette is ejected, the mechanism will stop at this position.
E Cassette IN standby. The guide will start protruding out as the mechanism moves towards the
LOAD position.
C Code during loading. Code outputs while the LS chassis is moving.
D LS operations and guide loading are performed here.
9 Current limiter is turned off.
Stop position in the loading state. The pinch roller separates, the tension regulator returns, and the
5
brake is imposed on both reels.
7 FF position. The tension regulator is half on. This position is not used except for the FF mode.
PB, REC, CUE, Pause, FX2, FWD-SLOW positions. When the pinch roller is pressed, and the
B tension regulator is ON, the mechanism is operating at this position in modes in which normal
images are shown.
3 Reverse running position. REW, REV, RX1, RX2, and RVS-SLOW are performed at this position.
Code not existing in the MD. When errors occur when the loading motor is not driving, this code is
0
memorized.
LE BL STOP BL FF
Contents
5-52
LOAD →
BL RP BL RVS
Pinch roller is pressed
Tension regulator ON