Cabinet (R) Assembly, Pd-102 Board - Sony Handycam DCR-PC1 Service Manual

2-5. CABINET (R) ASSEMBLY, PD-102 BOARD

@¢ Remove the
claw with
@¶ Remove
tweezers or
the soldering
the like.
@∞ Close the
LCD.
@§ SW clip
@• PR-31 board
6 Harness (PD-107)
8 Screw
(0-No. +P2 M1.7)
!• PD-102 board
1 Two screws
(0-No. +P2 M1.7)
3 LCD cabinet (R)
2 Disengage the claws by
moving it in the direction
of arrow a .
@£ LCD hinge assembly
@™ Two screws
(M1.7)
#¢ Screw (M1.7)
#™ Harness (SP-158)
@ª Two screws
(M1.7)
#¡ Speaker
#º Speaker retainer
#£ DV jack cover assembly
!∞ Remove the solderings.
!§ PCB clip
P D
- 1 0
B O
2
A R
D
a
a
!¡ Remove
soldering.
7 Connector (PD-102 board CN8200)
Cabinet (R) assembly
#• LCD lock pin
#ª LCD lock retainer
$º LCD lock
b
(2.0 cm)
#∞ S-terminal
cover assembly
Remove the rotary axis of the
5
LCD hinge assembly and the
LCD cabinet (L).
!£ Remove
the claws.
b
a
!º LCD
!¢ Cold cathode florescent tube
!£ Remove the claws.
9 Screw (0-No. +P2 M1.7)
!¶ Inverter transformer unit
!™ Remove the claws.
@¡ BL shielding sheet
!§ PCB clip
!ª BL insulation sheet
@º PD insulation sheet
2-4
#¶ Push the area
$¡ Compres-
sion coil
spring
#§ Control switch
block (ME-4780)
4 Two screws
(0-No. +P2 M1.7)
Rotate the LCD cabinet
assembly by 90 degrees
and remove the screws.
!™ LCD cabinet (L)
shown by the
arrow.