Touch Sensor - FUTABA 14SG S.Bus2 Instruction Manual

Touch sensor operation
Data input operation is performed using the touch sensor.
SensorTouch™ operation
• Short 'tap'
S1
RTN
• Two short 'taps'
SYS
LNK
MDL
• Touch and hold for
one (1) second.
S1
RTN
• Scrolling
Outline
of
"RTN"
Movement of cursor, value input or mode selection:
Movement of the cursor on the menu screen and
movement of the cursor among items on a setup
screen can be controlled by scrolling your finger
to the left and right in the direction of the arrow in
the scrolling diagram above. You can also go to the
next page, if there is a next page.
This scrolling technique is also used for data
input, value input, mode selection, and similar
operations. Examples include: Value, ON, OFF,
INH, ACT, etc.
RTN button:
Touch the RTN button when you want to open
a setup screen or to switch between cursor move
mode (reverse display) and data input mode (box
display).
This button can also be used as the enter button
when a confirmation message is displayed on the
screen, etc.
16 <Before Use>
Condition
If the screen has more than one page. (Ex. P-MIX screen)
If the screen have only one (1) page.
If inputting data while the cursor is blinking.
At the moving cursor mode.
While in the data input mode.
While inputting data while cursor is blinking.
At all screens
At all screens
At all screens
At the HOME screen
While inputting data with no blinking cursor.
Lightly circling the outside edge of the RTN button.
During the data input mode.
S1 button:
setup screen, you can go to that page by touching
the S1 button. In this case, the cursor moves to the
screen title item of the page.
Exiting setup screen:
to the menu screen, move the cursor to the screen
title item and touch the RTN button.
button for 1 second.
item and touch the RTN button to return to the
home screen from a menu screen.
Working
The cursor moves to the top of next page.
The cursor moves to the top of page.
The input data is canceled.
Change to the input data mode.
Changes to the moving cursor mode.
The data is entered.
Jump to System Menu screen directly.
Jump to Linkage Menu screen directly.
Jump to Model Menu screen directly.
Key lock On or Off
Reset to the initialized value.
The cursor moves accordingly.
Increases or decreases values accordingly.
When there is a next page on a menu screen or
To end the operation on a setup screen and return
To return to home screen directly, touch the S1
Alternatively, move the cursor to the screen title