Razor e100 Owner's Manual page 7

REPAIR AND MAINTENANCE
q Chain and Rear Tire Replacement
Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 13mm wrenches.
1
With a Phillips screwdriver,
loosen the two screws and
remove the chain guard.
4
Remove wheel.
Note the sequence of the hardware:
Right Side (Throttle)
18-1 M8 Nut
18-2 Washer
18-3 Axle adjuster eye bolt 18-3 Axle adjuster eye bolt
18-4 U Piece
18-5 M6 Locknut
18-6 Cap
18-7 Plate cut washer
18-8 Thick cut washer
18-9 (Short) spacer
5
Install new chain or wheel by
maneuvering the chain onto the
sprocket and slipping the axel
into the slots on the frame.
8
Replace the chain guard.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.
2
With a 10mm wrench, loosen
both axle adjusters an equal
amount, approximately five
turns.
Left Side (Brake)
18-1 M8 Nut
18-2 Washer
18-4 U Piece
18-5 M6 Locknut
18-6 Cap
18-7 Plate cut washer
18-8 Thick cut washer
18-9 (Long) spacer
6
Install the axle adjusters and
axle nuts. Tighten until they
just barely hold the hardware
in place.
3
With two 13mm wrenches,
loosen the axle. Slide the wheel
forward to loosen the chain.
18-1
18-2
18-3 18-7
18-8
18-11
18-10
18-4
18-5
18-6
18-4
18-5
18-6
7
Tighten both axle adjusters
the same number of turns to
fine-tune the tension on the
chain and center of the wheel.
6
18-9
18-8
18-7
18-3
18-2
18-1