Hardware Maintenance; Repair And Maintenance; Adjusting The Brakes - Razor e100 Owner's Manual

CONNECTORS/HARDWARE MAINTENANCE
q
Brake
Check the brakes for proper function. When you squeeze the lever,
the brake should provide positive braking action. When you apply
the brake with the speed control on, the brake cut-off switch
should stop the motor. Make sure that brakes are not rubbing.
Frame, Fork and Handlebars
q
Check for cracks or broken connections. Although broken frames
are rare, it is possible for an aggressive rider to run into a curb
or wall and wreck and bend or break a frame. Get in the habit of
inspecting your scooter on a regular basis.
q
Tires
Periodically inspect the tires for excess wear, and regularly check
the front tire pressure and re-inflate as necessary.
tires to the correct PSI and charged the battery for at least 18 hours.

REPAIR AND MAINTENANCE

Turn power switch "OFF" before conducting any maintenance procedures.
q Adjusting the Brakes
Tools required: 10mm wrench
1
To adjust the brake cable
play, thread the brake lever
adjuster in or out 1/4 to 1/2 turn
until the desired brake adjust-
ment is attained. Most
adjustments are complete at
this step. If brake still needs
further adjustment, proceed to
step 2.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll free 866-467-2967 Monday - Friday 8AM - 5PM Pacific Time.
Do not use this product for the first time until you have inflated the
Failure to follow these instructions may damage
your product and void your warranty.
2
If brake is too tight or has
too much slack, use a 10mm
open wrench. Loosen the brake
cable and adjust accordingly.
q
Safety Gear
Always wear proper protective gear such as an approved safety
helmet. Elbow pads and kneepads are recommended. Always
wear athletic shoes (lace-up shoes with rubber soles), never ride
barefooted or in sandals, and keep shoelaces tied and out of the
way of the wheels, motor and drive system.
q
Battery
Make sure the power switch is turned off whenever the scooter is
not in use. Never store the product in freezing or below freezing
temperatures! Freezing will permanently damange the battery.
3
Inspect the brake pads (A)
for proper alignment against
the wheel or excess wear. To
realign brake pads, loosen the
fixing nut (B) and adjust the pad
to contact the rim. Retighten
and test. Readjust as needed.
4