Installing The Handle - Toro CCR 2450 GTS Series Operator's Manual

Figure 4
4. Insert the loose end of the control cable into the bottom
hole in the control bar (Fig. 5).
1
4
5
Figure 5
1. Top hole
2. Bottom hole
3. Control bar
5. Fully insert the handle locks (Fig. 3).
Important
Ensure that the control cable is not pinched
by the upper handle or the handle lock.
6. Tighten the knobs until they are snug.
7. Adjust the control cable. Refer to Adjusting the Control
Cable on page 16.
3
2
4. Spring cover
5. Control cable

Installing the Handle

Models 38517 and 38518
1. Cut the plastic tie that secures the control cable to the
handle (Fig. 6).
1
2
Figure 6
1. Handle
2. Plastic tie
Important If you do not cut the plastic tie, the rotor
brake will not function properly.
2. Loosen the knob and pull out the handle lock on the
right side of the handle until the upper handle rotates
freely (Fig. 7).
1
2
Figure 7
1. Knob (2)
2. Curved washer (2)
3. Position the upper handle as shown in Figure 8.
8
3
3. Control cable
3
4
3. Upper handle
4. Handle lock (2)