Assembly; Loose Parts; Unfolding The Handle - Toro CCR 2450 GTS Series Operator's Manual

Assembly

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

DESCRIPTION
Knob
Curved washer
Handle lock
Screws
Locknuts
Washers
Discharge chute
Chute handle (Models 38515 and 38516 only)
Bolts
Locknuts
Chute crank and mounting bracket
Ignition key
Power cord (electric-start models only)

Unfolding the Handle

Models 38515 and 38516
1. Cut the plastic tie that secures the control cable to the
handle (Fig. 2).
1
2
Figure 2
1. Handle
2. Plastic tie
QTY.
3
3. Control cable
1
Installing the handle (Models 38517 and 38518
1
only)
1
3
3
3 Installing the discharge chute
1
1
2
Installing the chute crank (Models 38517 and
2
38518 only)
1
1 Starting and stopping the engine
1 Starting the engine
Important If you do not cut the plastic tie, the rotor
brake will not function properly.
2. Loosen the knobs and pull out the handle locks until the
upper handle rotates freely (Fig. 3).
1
Figure 3
1. Knob (2)
2. Upper handle
3. Position the upper handle as shown in Figure 4.
7
USE
2
3
3. Handle lock (2)