Table of Contents
Advertisement
4.5.4 Checking PAM Block
PAM control signal
PA_ON : WCDMA Tx Power Detect IC(HDET) Enable
PA_RO: WCDMA Tx Power Amp Gain Control
PAM_OUT
PAM_IN
PA_FET_N must be LOW if the max Tx power is set (lower than 0.5V)
Copyright © 2007 LG Electronics. Inc. All right reserved.
Only for training and service purposes
PA_ON must be HIGH(over 2.5V)
- 97 -
4. TROUBLE SHOOTING
LGE Internal Use Only
Advertisement
Table of Contents
