Enamelled Parts; Replacing The Oven Light Bulb - Prestige PR 60 FSDOE Instructions For Use - Installation Advice

Ceramic cooker with double oven
Table of Contents

Advertisement

8
Important:
Before cleaning or carrying out
any maintenance disconnect the
appliance from the electrical sup-
ply and wait for it to cool down.
Attention
The appliance gets very hot,
mainly around the cooking areas.
It is very important that children
are not left alone in the kitchen
when you are cooking.
Do not use a steam cleaner
because the moisture can get
into the appliance thus make it
unsafe.
STAINLESS STEEL, ALUMINIUM
PARTS AND SILK-SCREEN PRINTED
SURFACES
Clean using an appropriate product.
Always dry thoroughly.
IMPORTANT: these parts must be
cleaned very carefully to avoid scratching
and abrasion. You are advised to use a
soft cloth and neutral soap.
CAUTION: Do not use abrasive
substances or non-neutral detergents
as these will irreparably damage the
surface.
CLEANING

ENAMELLED PARTS

All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a soft cloth.
Acidic substances like lemon juice,
tomato sauce, vinegar etc. can damage
the enamel if left in contact for too long.
VITROCERAMIC COOKING HOB
– See page 10
OVEN
The oven with smooth enamel must be
cleaned after every use using a suitable
product.
Remember that operating the oven for
30 minutes on the highest temperature
eliminates most grime and grease.
It is mandatory not to use abrasive sub-
stances.

REPLACING THE OVEN LIGHT BULB

Switch the cooker off at the mains.
When the oven is cool, unscrew and
replace the bulb with another one
resistant to high temperatures (300°C),
voltage 230 V (50 Hz), 15 W, E14.
Note: Oven bulb replacement is not
covered by your guarantee.
MAINTENANCE
AND
21

Advertisement

Table of Contents
loading

Table of Contents