Sony CFD-F17CP Service Manual page 17

Adjustment Location:
– TUNER board (component side) –
TP (ANT)
(CONDUCTOR SIDE)
T1 T1
AM
IF
ADJUSTMENT
T2 T2
FM
IF
ADJUSTMENT
CD SECTION
CD section adjustments are done automatically in this set.
In case of operation check, confirm that focus bias.
FOCUS BIAS CHECK
1. Connect the oscilloscope between IC701 pin 4 and pin qa
(or TP (RF) and TP (VC)).
2. Insert the disc (YEDS-18). (Part No. : 3-702-101-01)
3. Press the NX (CD) button.
4. Confirm that the oscilloscope waveform is as shown in the
figure below. (eye pattern)
A good eye pattern means that the diamond shape (◊) in the
center of the waveform can be clearly distinguished.
• RF signal reference waveform (eye pattern)
VOLT/DIV : 50 mV (10 : 1 probe in use)
TIME/DIV : 500 nS
When observing the eye pattern, set the oscilloscope for AC range
and raise vertical sensitivity.
CT3, L3
TRACKING
ADJUSTMENT
L3
L1 CT1 CT1, L1
FM
TRACKING
ADJUSTMENT
L2
IC1
L2
FM
FREQUENCY
COVERAGE
ADJUSTMENT
RF level :
0.85 ± 0.2 Vp-p
AM
CT3
L4 L4
AM
FREQUENCY
COVERAGE
ADJUSTMENT
Test Point:
– CD/MP3 board ( side B) –
CFD-F17CP
TP (VT)
(CONDUCTOR SIDE)
IC2
IC701
TP
TP
(TE)
(FE)
TP
(RF)
TP
(VC)
17