Installing A 2.5-Inch Hard Disc Drive - HP EliteOne 705 G1 Maintenance & Service Manual

4. If there is a second disc drive in the 2.5-inch cage, disconnect both cables from it.
5. Remove the four mounting screws from each 2.5-inch hard disc drive to be removed. Be sure to keep
the screws together with the blue rubber grommets to use to install a replacement drive.
NOTE:
must occupy this position.
6. Remove the 2.5-inch hard disc drive(s) from the cage.
For instructions on installing a hard disc drive, see

Installing a 2.5-inch hard disc drive

1. Insert the 2.5-inch hard disc drive into the drive cage.
●
To install a primary hard disc drive, insert the drive into the lower position in the drive cage. Be
sure to insert the end with the connectors first.
NOTE:
it must occupy this position.
● To install a secondary hard disc drive, set the drive into the upper tray of the drive cage. Be sure
the connectors are facing the same direction as the connectors of the primary hard disc drive.
36 Chapter 5 Removal and Replacement Procedures
The primary drive is the lower position in the drive cage. If only one drive is to be installed, it
The primary drive is the lower position in the drive cage. If only one drive is to be installed,
Installing a 2.5-inch hard disc drive on page 36.
ENWW