Indirect-Fired Storage Water Heater
INSTALLATION AND OPERATING INSTRUCTIONS
Contents
Heater Package includes:
• Fully insulated stainless steel tank with temperature
control well installed.
• Temperature control adjustable from 120°F to 160°F.
• Temperature and pressure relief valve.
• Plumbing hardware for installing T&P valve.
Page
WARNING - HOT WATER CAN SCALD!
Read all of the following important warnings to avoid
the possibility of personal injury, death, or property
damage.
• Keep temperature control on heater at lowest
setting which is satisfactory.
• Always adjust water temperature from taps by start-
ing with a cool mix of water and gradually bring to
warmer temperature.
• Never leave children, elderly or disadvantaged per-
sons unattended where hot water taps are located.
WARNING TO THE INSTALLER AND
• Keep temperature control on heater at lowest setting
which is satisfactory.
• Installation of a temperature and pressure relief valve
of the proper rating for the heater tank size is
required.
• Install a tempering device, such as a mixing valve, on
hot water piping which feeds areas where high
temperature water is not demanded.
• When servicing this installation, make sure drain con-
nections are tight and drain hose is directed away
from all persons or areas where injury or damage can
occur.
WARNING TO THE USER:
SERVICEPERSONS:
Publication No. WH-40 Rev. B
Part No. 66-4001