Checking The Rear Wheel Hubs; Installing The Wheel Hubs - Yamaha Raptor 90 YFM90RA 2011 Service Manual

FRONT AND REAR WHEELS
WARNING
_
Eye protection is recommended when
using striking tools.
c. To install the wheel bearings, reverse the
above sequence. Use a socket that
matches outside diameter of bearing outer
race to drive in bearing.
NOTICE
Do not strike the center race or balls of the
bearing. Contact should be made only with
the outer race.
EBS00384

CHECKING THE REAR WHEEL HUBS

The following procedure applies to both of the
rear wheel hubs.
1. Check:
• rear wheel hub
Cracks/damage → Replace.
• wheel hub splines
Wear/damage → Replace.
EBS00390

INSTALLING THE WHEEL HUBS

The following procedure applies to both of the
front and rear wheel hubs.
1. Install:
• axle nut
Front wheel hub:
Rear wheel hub:
• cotter pin
TIP
Do not loosen the axle nut after torquing it. If
the axle nut groove is not aligned with the cot-
ter pin hole, align the groove with the hole by
tightening the axle nut.
6 - 4
CHAS
65 Nm (6.5 m · kg, 47.0 ft · lb)
135 Nm (13.5 m · kg, 97.6 ft · lb)
New