3
3
Getting started
Setting the unit
When you use the unit for the first time, the following screens
will be displayed.
Set up the following items to customize the unit.
1
Press /I STANDBY/ON.
The power indicator flashes slowly. About twenty seconds
after turning on the power, the following screen appears.
About thirty seconds are required between turning the
power on and completion of startup.
When powering up for the first time
When you turn on the power to the unit for the first time, initial
settings will be automatically performed, thus startup will take
about one minute.
•
After the Pioneer logo is displayed, the screen will go dark.
The start up process is complete once the Pioneer logo is
displayed a second time.
14
Auto power off setting
Power to the unit will turn off automatically if no controls are
performed for the set period of time.
•
The factory default setting is 15 min.
Setting auto power off
1
Press SETUP.
The Initial Setup menu is shown on the display.
2
Select "Option Setting".
3
Select "Power off Setting".
4
Select "Auto Power Off".
Use / to select time until the power automatically
5
turns off, then press ENTER.
Select from 15 min/30 min/60 min or Off (power will not
turn off automatically).
6
Press RETURN and complete settings.
General control
Input function
When pressing SOURCE button on the unit, the current
function will change to different mode. Press SOURCE button
repeatedly to select desired function. The selected input is
displayed on the front panel display.
Headphones (N-70A only)
•
When the headphones are connected, the volume will be
displayed on the screen.
•
The volume cannot be changed when the headphones are
unplugged from the unit.
•
Insert the headphone terminal while the headphone is not
against your ear, check the volume, and then attach the
headphones to the ear.
•
Be sure your headphone has a 3.5 mm diameter plug and
impedance between 16 and 600 ohms. The recommended
impedance is 32 ohms.
•
The factory default setting is 0 (MIN).
Volume
36
Brightness control for display and each indicator
Press DIMMER button to dim the brightness of the display
and each indicator.