Connecting The Other Pioneer Devices And Controlling Centrally - Pioneer N-70A-K/-S Operating Instructions Manual

2
2
Connecting using wireless LAN
Wireless connection to the network is possible through a
wireless LAN connection. Use the separately sold wireless
LAN converter (Pioneer Model No. AS-WL300) for connection.
DIGITAL OUT DIGITAL IN

2 1
OPTICAL COAXIAL OPTICAL COAXIAL
LAN (10/100)
DC OUTPUT CONTROL DIGITAL IN
For
OUT
WIRELESS
iPod/iPhone
LAN
(5V 0.6A MAX) 5V 1A USB DAC
Cable included with the
Wireless LAN converter
(AS-WL300)
LAN
DC 5V Ethernet WPS
Wireless LAN converter (AS-WL300)
(commercially available)
Note
• Use only the furnished accessory connecting cable.
• For instructions on setting the wireless LAN converter, refer
to the operating instructions for the AS-WL300.
12
Connecting the other Pioneer devices and
controlling centrally
When a Pioneer Amplifier's/CD player's control terminal is
connected with this unit, the connected amplifier/CD player
can be operated with the Pioneer ControlApp.
Please see the following website for amplifiers/CD players
Internet
that are compatible with the Pioneer ControlApp.
http://pioneer.jp/support/soft/iapp_controlapp/en.html (for
iPhone/iPod touch)
http://pioneer.jp/support/soft/aapp_controlapp/en.html (for
Android)
Modem
You can also centrally control Pioneer products with control input
terminals using this unit's remote sensor. Those devices that do
not have remote sensors or devices that are located where it
cannot receive signals can also be operated remotely (*1).
*1: Using the unit's remote sensor, you can remotely operate
the devices connected to this unit with their remote
controllers.
3 2 1 WAN
Wireless LAN
router
Control cable
(commercially available)
IN
OUT
To the CONTROL IN terminal
CONTROL
of other Pioneer products
with control input terminal
Other Pioneer products with
control input terminal
CONTROL
OUT
NETWORK AUDIO PLAYER
/I STANDBY/ON
SOURCE SOURCE  
STANDBY DIRECT Hi-Bit 32 Up Sampling
 
5V 1A
iPod/iPhone
Important
• When connecting the control terminals, please make sure
that the audio cable (analog connection) that is included
with the unit is also connected. The connection using the
control terminals alone will not allow proper operation of
the central control.
Note
• Use a commercially available cable with mono mini-plug
(with no resistance) for connection.
• When connected, the remote sensor for the amp and CD
player will cease to function, and the remote sensor on this
unit will receive the signals for the amplifier/CD player.
Point the remote control towards this unit to operate.
• When this unit's network standby is set to off, this unit
cannot operate the amplifier or CD player. They can be
operated when the network standby for this unit is set to on.
N-50A
Connecting your equipment