V I I I . D I S A S S E M B L Y A N D A S S E M B L Y - Pride Legend Owner's Manual

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y

sembly and assembly. No tools are required. Always disassemble or assemble your Scooter on a level, dry surface
with sufficient room for you to work and move around your Scooter. Keep in mind that the disassembled sections
of the Scooter take up more floor space than the assembled Scooter.
DISASSEMBLY
You can disassemble the Scooter into seven pieces: the seat, the front frame, the front basket, the rear frame, the
rear shroud, and the two batteries. Place the Scooter in an area where you have sufficient clearance to move the
parts around. You need about 1.5 meters in all directions. You may need assistance to lift some of the Scooter
components. See III. “Specifications” for individual component weights.
1. Remove the key from the key switch.
2. Place the manual freewheel lever in the drive (down) position to make it easier for you to maneuver the rear
section.
3. Ensure the seat is locked into position; then lift the seat up and off of your Scooter. See figure 18.
4. Gently lift the rear shroud off of your Scooter. See figure 19.
5. Disconnect the battery tie-down straps (if so equipped).
6. Unplug both battery harnesses; then lift both batteries from the battery wells. See figures 20 and 21.
7. Unplug the front-to-rear connector that attaches the front control console harness to the electronics module
harness. See figure 22.
CAUTION! Failing to unplug both battery harnesses and the front-to-rear connector prior to further
disassembly could result in permanent damage to your Scooter.
8. Grab the handle grip on the tiller, pull up on the tiller adjustment lever, and gently lower the tiller down to the
center of the Scooter chassis until it is fully lowered.
9. Remove the ball detent pin from the frame. See figure 23.
10. Move the camlock levers to the unlocked, vertical position. See figure 24.
11. Place one hand on the seat post tower, one hand on the front frame handle and gently slide the front and rear
sections apart. See figure 25.
FIGURE 18. REMOVING THE SEAT
26
FIGURE 19. REMOVING THE SHROUD
Legend