Pride Legend Owner's Manual page 25

V I I . C O M F O R T
You can position the Scooter seat to one of five different
heights.
1. Remove the seat and rear shroud from your Scooter.
See VIII. “Disassembly and Assembly.”
2. Use the attached ring to pull and remove the ball detent
pin from the seat post tower. See figure 16.
3. Raise or lower the seat post to the desired seat height.
4. Hold the seat post at that height and match up the adjust-
ment holes in the seat post with the holes in the seat post
tower.
5. Fully insert the ball detent pin.
6. Replace the seat and the rear shroud.
POWER SEAT ACTUATOR (OPTIONAL)
Your Scooter may be equipped with a power seat actua-
tor. The actuator raises and lowers the seat automatically.
See figure 17.
WARNING! The power seat actuator is intended for operation only while the vehicle is sta-
tionary and on a level surface. Its purpose is to aid you in reaching objects. Strict adher-
ence to the following safety rules is vital to your safety:
n
Do not attempt to raise or lower the seat while in motion.
n
Do not operate your Scooter with the power seat elevated.
n
Drive the vehicle only with the seat in the lowest position.
Operating Your Power Seat
1. Ensure your Scooter is level and stationary.
2. Toggle on the power seat switch.
3. To raise the power seat, place your hands on the handgrips
and use your thumb to push the right throttle control le-
ver, located on the Scooter’s control console.
4. Release the lever when you have attained your desired
height.
5. To lower the power seat, place your hands on the
handgrips and use your thumb to push the left throttle
control lever, located on the Scooter’s control console.
6. Release the lever when you have attained your desired
height.
7. Ensure your seat is in the lowest position and toggle off
the power seat switch before you attempt to drive your
Scooter again.
The 3-wheel and 4-wheel Scooters are identical in disas-
Legend
A D J U S T M E N T S
SEAT POST
BALL DETENT PIN
FIGURE 16. SEAT HEIGHT ADJUSTMENT
FIGURE 17. POWER SEAT ACTUATOR (OPTIONAL)
ADJUSTMENT
HOLES
SEAT POST TOWER
25