Brother PD-3000 Instruction Manual page 80

CHAPTER 3 PROGRAMMING WITH ICONS
1. Select with
.
2. Press , and then press
The work clamp moves from the start point by each
stitch.
The work clamp moves. When the needle point is
at the start point for a multiple stitch, stop it by
pressing .
3. Press .
Deleting a part of current data
Preadjust the needle position to the first or last point of a part to be deleted.
Refer to "Checking the program setting and setting attribute" (page 78).
1. Select , and then press
72
, and then press
4. Select
.
5. Select
6. Input the stitch length and the number of lines,
2. Input the stitch count to delete.
.
3. Press
PD-3000
, and then press
, and then press
and then press .
Calculation is performed based on the input data.
When the calculation ends, the needle point moves
to the end point for a multiple stitch.
to delete data following the current
needle position for the input count. Press
to delete data prior to the current needle
position.
The corresponding data is deleted.
.
.