Table of Contents
Advertisement
the weather data collected by the Outdoor Sensor will not be affected by the temperature of the
air leaving the attic.
We have provided a mounting plate that you can attach to the wall with the supplied screws.
Gently snap the Sensor onto the holding pegs on the mounting plate after the plate is screwed to
the wall. When the holding pegs are securely locked into the slots on the Sensor, you will hear a
"Click".
Gateway Installation
Gateway.
NOTE: Network cables usually have length limitations. The same length
limitations will apply that apply to computers on your home network.
Online Resources
These links can help to enrich your Weather Direct® experience:
Help –
www.weatherdirect.com/help
•
For a list of places to choose from as forecast locations -
•
www.weatherdirect.com/places
Time Setting on Wireless Display
The Time Zone you select on
www.weatherdirect.com
Wireless Display is intended to set the
time for your physical location so the
clock on your Wireless Display is
accurate. This time is independent of
your selected forecast locations. The
Wireless Display will ONLY display the
time from the "Time Zone for Wireless
Display Clock" set on the web site,
NOT the time at the forecast locations.
There is only one Time Zone available
per Wireless Display.
The Daylight Saving Time (DST)
checkbox on your Wireless Display
settings at
www.weatherdirect.com
selected by default because most
The Gateway should be installed indoors in an easy-to-
reach location. Registration requires that you press the
gray button on the Gateway. It can be mounted
securely to the wall with the included mounting plate
and drywall anchors.
If you require a longer LAN cable to mount the Gateway
in a desired location, any standard Category 5 network
cable will work, but a crossover cable may not work.
Crossover cables designed to connect two computers
without networking hardware may not work with your
for your
is
Page 12 of 24
Version 2 - 12/22/2011
Advertisement
Table of Contents
