Wireless Outdoor Sensor Installation Options; To Surface Mount The Outdoor Sensor; To Wall Mount The Outdoor Sensor; Gateway Installation - La Crosse Technology WEATHER DIRECT WD-3103U Owner's Manual

4 day wireless forecast station
Hide thumbs Also See for WEATHER DIRECT WD-3103U:
Table of Contents

Advertisement

Wireless Outdoor Sensor Installation Options

NOTE: Move the Wireless Outdoor Sensor into its intended location and wait for
10 minutes to make sure the outdoor temperature is still being received by the
Wireless Display. Press the "SNOOZE" Key on your Wireless Display to show
the outdoor temperature. If the display shows - -,-F for the outdoor temperature,
the signal cannot reach the Wireless Display. Find a closer location to mount the
Wireless Outdoor Sensor and wait 10 minutes to check the Wireless Display
again for reception.
DO NOT mount the Wireless Outdoor Sensor in a permanent fashion until
you are sure the signal is being received by the Wireless Display.

To Surface Mount the Outdoor Sensor:

The Sensor can be positioned on a flat surface by securing the
stand to the bottom by gently pushing the bottom of the Sensor onto
the holding pegs of the stand until they click into place in the
grooves on the Sensor.

To Wall Mount the Outdoor Sensor:

The Outdoor Sensor is weather resistant, but not water proof. To
ensure maximum Sensor life, mount it in a covered place out of the
elements like under the eaves. Placement on the North side of your
home will provide the most accurate readings. Mount it about 18"
down from the eaves for optimum performance. This ensures that the
weather data collected by the Outdoor Sensor will not be affected by
the temperature of the air leaving the attic.
We have provided a mounting plate that you can attach to the wall with the
supplied screws. Gently snap the Sensor onto the holding pegs on the mounting
plate after the plate is screwed to the wall. When the holding pegs are securely
locked into the slots on the Sensor, you will hear a "Click".

Gateway Installation

The Gateway should be installed indoors in an
easy-to-reach location. Registration requires
that you press the gray button on the
Gateway. It can be mounted securely to the
wall with the included mounting plate and
drywall anchors.
Page 8 of 26
Version 1.6 - 07/01/2008

Advertisement

Table of Contents
loading

Table of Contents