Assembly And Set-Up - Razor E300 Series Owner's Manual

ASSEMBLY AND SET -UP
Attaching the Seat (E300S Series Only)
Tools required: Two (2) 4 mm Allen wrenches and Phillips screwdriver.
1
Attach the seat to the seat post
with two (2) 4mm Allen wrenches.
See note below.
Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or slightly tilted
depending on your personal preference. Tighten securely. The seat tilt adjustment should not move when riding.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
2
Remove the four screws on
the middle of the deck with the 4
mm Allen wrench and the Phillips
screwdriver.
3
Place the seat post on the deck
and secure using the same 4 screws.
4