Operating Instructions; Glass Information; Glass Cleaning; Log Installation - Majestic fireplaces GBR36 Homeowner's Installation And Operating Manual

Glass Information

Only glass approved for use in Majestic
Fireplaces products may be used for re-
placement.
•
Glass doors are optional. The
appliance may be operated safely without glass
doors.
•
The use of any non-approved replacement glass will
void all product warranties.
•
Bi-fold glass doors MUST BE completely open or
closed while the appliance is in operation.
•
Care must be taken to avoid breakage of the glass.
•
Under no circumstances should this appliance be
operated with broken glass. Replacement of the
glass as supplied by the manufacturer should be
completed by a licensed qualified service person.
•
Replacement glass is available through your
Majestic Fireplaces dealer and should only be
installed by a licensed qualified service person.

Glass Cleaning

It will be necessary to clean the glass periodically.
During start-up, condensation, which is normal, forms
on the inside of the glass and causes lint, dust and
other airborne particles to cling to the glass surface.
Also, initial paint curing may deposit a slight film on
the glass. It is therefore recommended that the glass
be cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend
gas fireplace glass cleaner). After that the glass should
be cleaned two or three times during each heating
season depending on the circumstances present.
Clean glass after first two weeks of
operation.

Log Installation

1. Open glass door (if installed).
2. Remove logs from the packaging. (As with all plastic,
these bags are not toys and should always be kept
away from children and infants.)
3. Place rear log on back bracket. Ensure that log is
firmly positioned and there is no side-to-side move-
ment.
4. Place the front log on the front burner (starting to-
ward the rear of the front burner) and slide it forward
until the notches lock into place.
5. Place the top logs onto the locator notches. Ensure
that the logs are secure. (Fig. 12)
7412955

Operating Instructions

GBR Series B-Vent Gas Fireplace
Left
Crossover Log
Back
Log
Front
Log
Fig. 12 GBR36 log placement.

Ember Material Placement

Separate the ember material into small pieces, roughly
LG237
1/2" in diameter and place on the front burner tube. Do
GBR logs
not pack down; leave in loose, fluffy condition for most
5/21/02 djt
realistic ember effect. (Fig. 13)
(Overhead View)
Fig. 13 Ember placement.
LG238

Lava Rock

GBR logs
top vu
The lava rock provided with this fireplace must be
ember placement
placed on the firebox base on either side of the burner
5/21/02 djt
assembly.
Under no circumstances should lava rock
be placed on any part of the burner assem-
bly.
Right
Crossover Log
LG237
LG238
11