Honeywell T7350 User Manual page 5

2. Use a pencil to mark the mounting holes. (See Fig. 5.)
3. Remove the subbase from the wall and drill two 3/16 in.
holes in the wall (if drywall) as marked. For firmer
material such as plaster or wood, drill two 7/32 in. holes.
4. Gently tap anchors (provided) into the drilled holes until
flush with the wall.
5. Position the subbase over the holes, pulling wires
through the wiring opening.
6. Loosely insert the mounting screws into the holes.
7. Tighten mounting screws.
SUBBASE
T4
T7770A
T T
T7770A
T T
Fig. 3. Four T7770A Sensors providing temperature
averaging network for T7350 Thermostat.
T3
T7770A
T T
T7770A
T T
M19606A
T7350 COMMERCIAL PROGRAMMABLE THERMOSTAT
T7770A
T T
T7770A
T T
T7770A
T T
Fig. 4. Nine T7770A Sensors providing temperature
averaging network for T7350 Thermostat.
WIRES THROUGH WALL
WALL
ANCHORS
(2)
Fig. 5. Mounting the subbase.
5
SUBBASE
T4 T3
T7770A T7770A
T T T T
T7770A T7770A
T T T T
T7770A T77770A
T T T T
M19607A
MOUNTING
HOLES
MOUNTING
SCREWS
M19608
63-2605—2