Honeywell T7350 User Manual page 25

To configure a T7350:
1. From the opening screen, tap Select Existing Config.
(See Fig. 22.)
2. Select the desired configuration.
Fig. 22. Select Existing Config.
3. This brings up the Summary screen. From here, you
can make changes using the:
a. Novice navigation screens (that appear), or
b. Advanced navigation screens, using the hidden
menus. (These are designed for expert users.)
(1) Access to the Advanced Navigation mode is
obtained using one of the following methods:
(a)Tap the lower left "Menu" silk screen icon.
(b)Tap the Title Tab of any screen.
RESULT: The Config Tool replaces the existing Screen
Title Tab with the Advanced Navigation menu
displayed across the top of the screen.
4. Tap "SaveAs" to save the changes under a new name.
5. The Summary screen facilitates changes to:
a. Description.
b. Model.
c. Control (Standard or Heat Pump).
Fig. 23. Configuration Summary screen.
6. Make changes and tap "Next" to proceed to the Inputs
screen.
7. The Inputs screen facilitates changes to:
a. RoomTemp(erature).
b. Room Rel(ative) Humidity.
c. Occ(upancy) Sensor.
d. Discharge Air Temp(erature).
e. Outdoor Air Temp(erature).
NOTE: Some selections only appear for the models
that support them.
T7350 COMMERCIAL PROGRAMMABLE THERMOSTAT
Fig. 24. Inputs screen.
8. Make changes and tap "Next" to proceed to the Cooling
Config(uration) screen.
9. The Cooling Config screen facilitates changes to:
a. Number of Stages.
b. Cooling Response.
c. OAT Lockout and DAT Low Limit Setpoints (for
some models).
T7350D
Fig. 25. Cooling Config(uration) screen.
10. Make changes and tap "Next" to proceed to the Heating
Config(uration) screen.
11. The Heating Config(uration) screen facilitates changes
to:
a. Number of Stages.
b. Heating Response.
c. OAT Lockout and DAT High Limit Setpoints (for
some models).
T7350D
Fig. 26. Heating Config(uration) screen.
25
T7350M
T7350M
63-2605—2