Finishing; Door Removal; Glass / Door Replacement - Napoleon BGD42N Installation And Operating Instructions Manual

28

5.0 FINISHING

5.1

DOOR REMOVAL

The door latches are part of a safety system and must be properly engaged. Do not operate the
Facing and/or finishing materials must not interfere with air flow through air openings, louvres
openings, operation of louvres or doors or access for service. Observe all clearances when
Do not strike, slam or scratch glass. Do not operate appliance with glass removed, cracked, broken
Before door is removed turn the appliance off and wait until appliance is cool to the touch. Doors are
Before the glass door can be removed, the op-
tional front, louvres and insets must be removed.
The glass door is secured to the top front edge
of the fi rebox with two latches. Pull the handles
of the latches forward, then lift the latches out
from the door frame to release the top of the
door. Next, pivot the door forward until the top
edge clears the front of the appliance. Carefully
grip the sides of the door lifting it out from the
retainer along the bottom of the door.
5.2

GLASS / DOOR REPLACEMENT

• Place the door frame face down careful not to scratch the
5.2.1
paint.
• Center the gasketed glass inside the door frame with the thick
5.2.2
side of the gasket facing up.
5.2.3 • Bend the glass retainers located along the edge of the door
frame over the gasket holding the glass in place. Careful not to
break the glass.
W415-0777 / 03.02.09
WARNING
!
Glass may be hot, DO NOT touch glass until cooled.
appliance with latches disengaged.
applying combustible materials.
or scratched.
heavy and fragile so handle with care.
FIGURE 5.1
GASKET
GLASS
RETAINER
FIGURE 5.2c
FIGURE 5.2a
GLASS
DOOR FRAME
56.1