Nailing Tab Installation; Minimum Mantel Clearances - Napoleon BGD42N Installation And Operating Instructions Manual

26
4.1

NAILING TAB INSTALLATION

4.1.1
• Attach the nailing tabs to the
corner posts using the 2 sheet
metal screws supplied. Secure
through the centre of the top
and bottom slots in the nailing
tab and then through the exist-
ing holes in the corner posts.
If there are no existing holes,
follow these instructions:
• Position the nailing tab so that
the front face is offset with the
front edge of the corner post
4.1.2
(approx. ½"). Centre the nailing
tab vertically on the corner post.
• Drill through the centre of the
top and bottom slots in the nail-
ing tab. Secure using the two
sheet metal screws supplied.
4.1.3
This allows the nailing tab to slide
back and forth for desired framing.
• To determine the fi nal location of the nailing tab you
must fi rst determine the thickness of your fi nish-
ing material (i.e. drywall). This will determine the
4.1.4
dimension from the front edge of the corner post
to the nailing tab. Once the nailing tab is in the desired location, drill through the centre hole of the nailing
tab. Secure with a sheet metal screw*.
* Additional set screws may be installed.
4.2

MINIMUM MANTEL CLEARANCES

Risk of fire, maintain all specified air space clearances to combustibles. Failure to comply with
these instructions may cause a fire or cause the appliance to overheat. Ensure all clearances (i.e.
When using paint or lacquer to finish the mantel, the paint or lacquer must be heat resistant to
Combustible mantel clearance can vary according to the mantel depth. Use the graph to help evaluate the
clearance needed. Curtains, above the appliance, must not be positioned lower than the 5" distance required
for the 2" combustible mantel. These same requirements apply to any combustibles protruding on either side
of the appliance.
W415-0777 / 03.02.09
NAILING TAB
FIGURE 4.1a
back, side, top, vent, hearth, mantel, front, etc.) are clearly maintained.
FIGURE 4.1b
WARNING
!
prevent discolouration.
CORNER POST
NAILING TAB
TOP SLOT
FINISHING
MATERIAL
FIGURE 4.1c
CENTRE HOLE
55.1
FIGURE 4.2