Uniden BC246T Owner's Manual page 55

• 800MHz Standard - Use for 800 MHz systems that
use the standard band plan
• 800MHz Splinter - Use for 800 MHz systems that use
the splinter band plan (typically near international
borders)
• 900MHz Band - Use for 900 MHz systems
• VHF Band - Use for VHF systems
• UHF Band - Use for UHF systems
Next, refer to the appropriate section to set system-wide
options. For most settings, you can accept the default.
However, for the items in bold, you must enter
information in order for your scanner to scan the system.
• See "Editing the System Name" on Page 63
• See "Editing the System Quick Key" on Page 63
• See "Setting System Lockout" on Page 64
• See "Setting the System Hold Time" on Page 64
• See "Setting the Channel Delay Time" on Page 65
• See "Setting ID Scan/Search (Trunked Systems
Only)" on Page 65
• See "Setting the Base Frequency/Step/Offset (Motor-
ola UHF/VHF Systems Only)" on Page 66 (must be
set up for VHF or UHF systems)
• See "Editing the Fleet Map (Motorola Systems Only)"
on Page 67 (must be set up for Type I systems)
• See"Setting the Motorola Status Bit (Motorola Sys-
tems Only)" on Page 67
• See "Setting the End Code Operation (Motorola Sys-
tems Only)" on Page 68
• See "Setting I-Call (Motorola and EDACS Systems
Only)" on Page 68
• See "Setting Emergency Alert (Motorola and EDACS
Systems Only)" on Page 69
• See "Setting Control-Channel Only (Motorola Sys-
tems Only)" on Page 70
• See "Setting System Lockout" on Page 64
Programming Radio Systems
55