2.2.10 Flash LED
Check the Flash LED at the back side of phone whether it's
turned on.
Press Back key to return to Service Test Menu.
2.2.11 Bluetooth
During this test, the distance between the phone and the
target Bluetooth device must be 1.5 to 5 meters!
Make sure the target Bluetooth device is enabled and
visible always!
The Bluetooth test will be done in following sequences:
Step 1: Enable Bluetooth; wait 4-5 seconds, shows OK;
Step 2: Searching;
Step 3: Device Found list;
Step 4: Select the Target Bluetooth Device, and Type PIN
code to Pair;
Step 5: Type the Pairing PIN code on Target Bluetooth
Device also, when succeeded, it shows "Test
Complete".
Press Back key to return to Service Test Menu.
2.2.12 WLAN
Make sure there's WLAN network before performing this
test.
The WLAN test will be done in following sequences:
Step 1: Enable WLAN; wait 4-5 seconds, shows OK;
Step 2: Searching;
Step 3: Access points Found list;
Step 4: Select the Target WLAN network, and Type
Password to get connection;
Step 5: when Connection succeeded, it shows "Test
Complete".
Press Back key to return to Service Test Menu.
1230-2323 Rev 1
©
Sony Ericsson Mobile Communications AB – Company Internal
Test Instruction Repair Instruction Mechanical/
9(16)