Table of Contents
Advertisement
General Operating Instructions
3. DST: Daylight Saving Time, press [u
disable the daylight saving.
4. Antenna: Press [u
5. Auto Scan: Auto channel scan selection. Press [u
channel scan page and start scanning. You can also press "EXIT" to skip this operation and exit
this page. Refer to the section TV for detailed operation steps.
Standby
Press [POWER] on the remote control or power button on the panel to enter the standby state.
★Special Attention
1. If there is no signal input after turning on the TV, the system will auto enter the standby state a
few minutes later.
2. If you are not going to operate the TV soon, please press the power button to turn off the power.
Signal Source Selection
Press [SOURCE] on the remote control or on the panel to enter the menu
"Input Source". Press [▲] and [▼] on the remote control or [CH+] and [CH-]
on the panel to select a signal source, and then press [OK] on the remote
control to enter the signal input source you've selected.
OSD Menu Operation
Press [MENU] on the remote control or panel to display the main menu:
1. Press [t
] and [u
] on the remote control or [VOL-] and [VOL+] on the
panel to select a functional menu.
2. Press [▼] or [OK] on the remote control or [CH-] on the panel to enter the functional menu.
3. Press [▲] and [▼] on the remote control or [CH+] and [CH-] on the panel to select an adjustment
item from the functional menu.
4. Press [t
] and [u
] on the remote control to change the analog value. When there is an icon "u
on the screen, you can press [u
sub-menu or press [MENU] to exit the current menu.
5. No matter which menu you have entered, you can press [MENU] to exit the current menu, press
[EXIT] to exit the entire menu, press [SOURCE] to display the menu "Input Source", and then
press [SOURCE] to exit the menu "Input Source".
6. In menu operation, each disabled option is auto hidden with a purple icon. When you change the
OSD menu setting value, the new setting value will auto take effect upon the disappearance of
the menu even if you do not press the relevant key to exit the OSD menu.
7. The operating instructions provided in this User's Manual for the menu "Picture", "Sound",
"Setting" and "TV" are all based on TV Input Source. The operating steps in any other Input
Source are nearly same as TV Input Source. Please understand them by yourself.
], [▲] and [ ▼] in this Manual stand for the direction cursor keys on the remote control
], [ u
Note: [t
unless specifically defined. The operating instructions in the text below are all based on keys on the
remote control. Please understand the keys on the panel by yourself.
Below is a list of menu. Please find the detailed operating instructions in the later sections.
] on the remote control to select from On/Off to enable or
] to select the TV receiving mode from Air/Cable repeatedly.
] on the remote control or [VOL+] on the panel to enter the next
] on the remote control to enter the auto
10
INPUT SOURCE
TV
AV1
AV2
SV
YPBPR
HDMI1
HDMI2
VGA
"
Advertisement
Table of Contents
