Table of Contents
Advertisement
Remote Control
BATTERYREPLACEMENT
when the batteries become weak the operating distance of the remote control is greatly
reduced and you will need to replace the batteries.
Note: The remote control may differ from the above figure in appearance. The actual remote control
shall prevail.
Operating Notes for Remote Control
1. Aim the remote control at the remote receiving sensor. Any article placed between the remote
control and remote receiving sensor could affect the normal operation.
2. Do not shake the remote control violently or operate or put it under direct sunlight, as heat could
deform the remote control.
3. If the remote receiving sensor is located under direct sunlight or strong light, the remote control
could fail to work. Please change the light angle or TV angle or get closer to the remote receiving
sensor to operate the remote control.
4. Low battery power could affect the remote control distance, please replace the battery. If the
remote control is about to be idle for long or the battery is used up, please remove the battery to
avoid any leakage corroding or damaging the remote control.
5. Do not use any battery of other specifications. Do not mix the old and new batteries. Always
replace both batteries together.
6. Do not throw the battery into fire, charge it, or break it down. Do not charge, disassemble, heat or
burn the used battery or cause a short circuit to it. Please comply with the relevant environmental
protection regulations to dispose of the waste battery.
General Operating Instructions
Power On
Insert the power plug into the power socket, press the [
[POWER] on the remote control to turn on the TV.
Installation Guide-Setting
When you turn on the TV for the first time, the first
page is the setting menu below.
1. Menu Language: Menu language selection. Press
[t
] and [u
] on the remote control or [VOL-] and
[VOL+] on the panel to select an menu language
from English/Spanish/French, and then press [OK]
to confirm your selection and enter the next item
"Time Zone".
2. Time Zone: Press [t
control or [VOL-] and [VOL+] on the panel to select
your time zone from Eastern/Central/Mountain/
Pacific/Alaska/Hawaii/Atlantic, and then press [OK] to confirm your selection and enter the next
item "DST".
] and [u
] on the remote
] button on panel, and then press
Menu Language
Time Zone
DST
Antenna
Auto Scan
Select
9
Setup Wizard
English
Pacific
Off
Air
Move
Return
MENU
Advertisement
Table of Contents
