To Resume Speed; To Vary The Speed Setting - Jeep 2009 Commander Owner's Manual

150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To Resume Speed

To resume a previously set speed, push the RESUME
ACCEL lever up and release. Resume can be used at any
speed above 20 mph (32 km/h) for 3.7L, 4.7L and 5.7L
engines.

To Vary The Speed Setting

When the Electronic Speed Control is ON, speed can be
increased by pushing up and holding RESUME ACCEL.
Release the Electronic Speed Control lever when the
desired speed is reached, and the new speed will be set.
Tapping RESUME ACCEL once will result in a 1 mph
(2 km/h) (3.7L, 4.7L and 5.7L engines) speed increase.
Each time the Electronic Speed Control lever is tapped,
speed increases so that tapping the Electronic Speed
Control lever three times will increase speed by 3 mph
(5 km/h) (3.7L, 4.7L and 5.7L engines).
To decrease speed while Electronic Speed Control is ON,
push down and hold SET DECEL. Release the Electronic
Speed Control lever when the desired speed is reached,
and the new speed will be set.
Tapping the SET DECEL lever once will result in a 1 mph
(2 km/h) speed decrease. Each time the lever is tapped,
speed decreases.
NOTE: The Electronic Speed Control System has been
designed to shut down if multiple Electronic Speed
Control switch functions are operated simultaneously in
order to ensure proper operation. If this occurs, the
system can be reactivated by pushing the Electronic
Speed Control switch ON/OFF button and resetting the
desired vehicle SET speed.