While charging, noise enters the AM radio
■
Turn off the wireless charger and confirm that the noise has decreased. If the noise
decreases, continuously pushing the power supply switch of the wireless charger for 2
seconds, the frequency of the charger can be changed and the noise can be reduced.
Also, on that occasion, the operation indicator light will flash orange 2 times.
Important points of the wireless charger
■
If the electronic key cannot be detected within the vehicle interior, charging cannot be
●
done. When the door is opened and closed, charging may be temporarily suspended.
When charging, the wireless charging device and portable device will get warmer,
●
however this is not a malfunction.
When a portable device gets warm while charging, charging may stop due to the pro-
tection function on the portable device side. In this case, when the temperature of the
portable device drops significantly, charge again.
Operation sounds
■
When the power supply is turned on, while searching for the portable device a sound will
be produced, however this is not a malfunction.
Certification for the wireless charger
■
FCC Note: This equipment has been tested and found to comply with Part 18 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user' s authority to operate this equipment.
NX200t_U_OM78006U
6-4. Other interior features
451
6