Output Polarity - Peavey IPR2 5000 Operating Manual

Output Polarity

Equalization
The IPR2 DSP provides five bands of parametric EQ, Waves
™
Bypass
Set Channel EQ
The first screen in the EQ Sub Menu is the bypass screen. The channels can be bypassed independently or both A&B can be
bypassed together. Press the encoder until the cursor is under the desired parameter to change and rotate the encoder to change
the bypass mode. Press the cursor to return it to the upper left corner when done so you can scroll to other screens.
MaxxBass
®
Parametric EQ
Output Polarity
The output polarity can be inverted on either channel. Select
Normal or Invert in the polarity screen. If you create a crossover
with 12dB per octave filters, the high frequency output would
likely need to be inverted to maintain the proper phase
relationship at the crossover frequency. Temporarily inverting
the polarity of one channel of a multi-way system can also aid in
the setting of the delay for driver alignment. You can adjust the
delay for cancellation at the crossover frequency. Remember to
switch the polarity back to Normal when complete.
To return to the Main Menu, select Discard and Exit or Save
and Exit.
Maxx Bass enhancement and horn EQ on each channel.
® ®
EQ Bypass
The first screen in the EQ Sub Menu is the bypass screen. The
channels can be bypassed independently or both A&B can be
bypassed together. Press the encoder until the cursor is under
the desired parameter to change and rotate the encoder to
change the bypass mode. Press the cursor to return it to the
upper left corner when done so you can scroll to other screens.
The MaxxBass enhancement system interacts with the
®
high-pass filter for each channel to produce bass energy in a
frequency range the loudspeaker can handle. The higher the
MaxxBass number, the more the bass is enhanced.
®
There are five bands of parametric EQ for each channel. The
frequency can be set in 1/12 octave frequency steps. The filter
bandwidth is set and displayed in octaves. The level can be
adjusted over a +/- 15 dB range. Press the encoder to select the
desired parameter to adjust. Return the cursor to the upper left
corner when done to scroll to other screens.
31