Peavey IPR2 5000 Operating Manual page 27

Rear Panel
IPR2 7500 DSP
™
11
IPR2 5000 DSP
™
11
CONNECTING INPUTS
10
Input connections are made via the 3-pin XLR (pin 2+) or 6.3 mm plug combination connectors on the rear panel of the
amplifier. The inputs are actively balanced. The input overload point is high enough to accept the maximum output level of
virtually any signal source.
THRU/OUT JaCKS
11
This XLR jack supplies parallel output signals from the associated channel for patching to this amplifier and/or additional
power amplifier inputs. The Thru/Out jack is affected by the position of the associated Channel Mode switch. This XLR jack
also provides an unbalanced (tip/sleeve) output to be patched with single-conductor shielded cables.
CONNECTING OUTPUTS
12
All models have one combination 4 pole twist lock output connector per channel. Channel A ouput allows for CH A 1+ Pos / 1-
Neg and channel B 2+ Pos / 2- Neg to use a single 4 conductor speaker cable.
CIRCUIT BREaKER
13
In the unlikely event of operating conditions that may potentially damage the amplifier, the circuit breaker may trip. After
inspecting the cables and connections, the amplifier can be reset. If the circuit breaker trips a second time, contact the local
Peavey authorized service center.
aC POWER INLET:
14
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to this connector to
provide power to the unit. Damage to the equipment may result if improper line voltage is used. (See line voltage marking on
unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a
suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire
hazard, always make sure that the amplifier and all associated equipment is properly grounded.
NOTE: FOR U.K. ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal
which is marked by the letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire which is colored
blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored
brown must be connected to the terminal which is marked with the letter L, or the color red.
11
11
12
12
27
12
12
14
13
14
13